Do you have Furnace Problems? Do You How a Furnace Works? Is It Time to Upgrade and Lower Gas Bills?

Ft Worth Furnace Repair
Ft Worth Furnace Repair

Ft Worth area furnaces are usually fueled by electricity, propane, and natural gas. The most common furnaces use natural gas because it is inexpensive, commonly available, and clean burning. A gas forced-air heating unit starts to work when the temperature drops below a certain degrees on the thermostat. The pilot light fires up a burner located inside the combustion chamber. This action creates heat that is transferred to the heat exchanger. The heat exchanger is a metal chamber in which air flows in and then it is heated. The heated air then moves into a hot air plenum, and next it moves through ducts delivering hot-warm air throughout your Ft Worth, TX residence.

Check Your Furnace Filter

If you know sure that a whole month has gone by without you checking your Ft Worth furnace filter, then it is probably time to clean or replace the filter. You have to keep in mind that a clean filter maximizes your furnace’s performance and efficiency. Maintaining your furnace filter can also add longevity to your furnace and also decreases energy costs.

If a member of your immediate family suffers from allergies, you might want to consider purchasing a allergenic reduction filter and a ultraviolet air purifier. Before you open the front panel to change or clean your furnace filter always makes sure you have powered down your furnace for safety reasons. Never operate the furnace until a clean or new filter has been installed. See http://www.cortisyn.com/.

Fall Preseason Furnace Check-Up

When a local contractor comes to do a preseason furnace check-up, you should expect the following:

  1. Evaluate and tighten all electrical terminals and connections
  2. Adjust and clean gas burners 3. Adjust and clean pilot/ignition assembly
  3. Vacuum and brush the heat-exchanger and combustion chamber
  4. Inspect heat-exchanger for rusting, cracks, etc.
  5. Vacuum blower compartment
  6. Inspect flue assembly and gas drafting mechanism
  7. Test safety controls
  8. Test gas pressure
  9. Replace filters
  10. Clean blower motor and fan assembly
  11. Lubricate all moving parts
  12. Adjust all dampers
  13. Calibrate thermostat
  14. Perform a room-by-room check for electronic carbon monoxide poisoning.

Why Upgrade to a Two-stage and Variable Speed Ft Worth Furnace?

You should upgrade to a variable speed furnace in your Ft Worth home because they offer air quality, zoning, cooling efficiency, and electrical efficiency. Speed variables give you amazing airflow control. On the other hand, two-stage units run a lot longer and provide an even cool and heat distribution, with consistent comfort.

We provide consistent and reliable furnace repairs throughout the Fort Worth Texas and Dallas Metro Plex. Regardless of the brand, Trane, Carrier, Amana, Goodman, Lennox, Bryant, or other, we have the parts on our truck ready to install to get your system back up and running quickly. Call today to schedule a service. Or better yet call now for a preventive maintenance of your equipment and avoid major breakdowns later down the line.